KnowledgeArchives-Ensenior

Knowledge

Home

Knowledge

What can you do to maintain your LED lights?

September 29, 2021 LED Knowledge

Although LED lamps have many advantages, they can also be damaged if they are not paid attention to maintenance. Only when we take notice of the maintenance of LED lights in daily use, can we extend its lifespan as much as possible. 1.LED lights with poor quality must often fail. We need to purchase LED lights from reliable brands. 2.Instruction is always the only guide.…

Read more
How To Choose The Best Light For Your Garage

September 29, 2021 LED Knowledge

When you like to work in the garage or simply use it to store your supplies, LED lights can better improve your work efficiency. Now, we will provide you with a comprehensive shopping guide. We will discuss the factors that need to be considered before buying LED lighting for the garage.

Read more
Basic knowledge about LED light

May 31, 2021 LED Knowledge

At present, LED lighting has basically completely replaced incandescent light in the lighting field. Compared with Compact Fluorescent Lamp (CFL), LED lights also have obvious advantages. How do LED lights emit light? How were LEDs used for white lighting developed? Compared to traditional incandescent lights and CFLs, what are the advantages of LED lights?

Read more
What are the causes of LED light buzzing?

May 31, 2021 Common Problem

LED lights may have annoying noise when used, but the noise is often not caused by quality problems. It is a common problem caused by a variety of circumstances. There are usually three situations as follows: High-power appliances in the same circuit. When high-power appliances, such as microwave ovens and air conditioners, are turned on, they may cause noise or flicker due to excessive voltage.…

Read more
What you may need to know about different dimmers

May 30, 2021 Dimmer Knowledge

Phase-Cut Dimming Instruction “Phase-cut” dimmers means the ones which work by taking the line input power (120V “house power”) and modulating the signal to reduce the power to the load. By “chopping” the signal, the load experiences a lower voltage, resulting in a softer light output. Now there are two most common “phase-cut” controls: forward phase controls and reverse phase controls. Each has its benefits…

Read more